- Title
- On the microstructure and physical properties of hot pressed (Hf, Ti) C
- Creator
- Heiligers, Christiané
- Subject
- Transition metal carbides
- Date Issued
- 2007
- Date
- 2007
- Type
- Thesis
- Type
- Doctoral
- Type
- PhD
- Identifier
- vital:10532
- Identifier
- http://hdl.handle.net/10948/523
- Identifier
- http://hdl.handle.net/10948/d1011722
- Identifier
- Transition metal carbides
- Description
- The microstructure and physical properties of hot pressed (Hf, Ti) C have been investigated with the aim of producing a cutting tool material with similar hardness to that of WC-Co and TiC-based cermets. Sintered samples were hot pressed from HfC0.7 and TiC0.9 powders using powder metallurgical techniques and the processing cycle was optimized for this system. Ni was used as a binder in selected samples and C black was added to compensate for sub-stoichiometry and to aid in the reduction of oxides formed during milling. Microstructural analyses were performed by scanning and transmission electron microscopy (SEM and TEM) and the composition was determined from X-ray diffraction (XRD) and energy dispersive X-ray spectrometry (EDS). The physical properties measured are density and Vickers hardness, and the indentation fracture toughness was determined using the Shetty formula. The fundamental interactions between HfC, TiC and Ni during hot pressing were investigated and the results obtained used to explain the microstructure that develops in samples made from powder mixtures. The interactions studied are the inter-diffusion of HfC and TiC through the solid state, and the dissolution and re-precipitation rate of the carbides in a liquid Ni binder. EDS analysis revealed that the rate at which Ti diffuses into HfC is higher than the rate at which Hf diffuses into TiC. Upper limits to the diffusion coefficients for these processes are determined and show that solid solution carbides will form from HfC + TiC powder mixtures at 2000 ºC in 1 hour if the average powder particle size is less than 5 μm. The diffusion rates decrease with a decrease in hot pressing temperature but mass transport between the phases can be enhanced by addition of a metallic binder. TEM and EDS analysis shows that Ni wets TiC more efficiently than HfC and that the solubility of TiC in Ni is also higher than that of HfC. The grain size of the carbide phases increases with an increase in the rate at which they dissolve into and re-precipitate from the liquid binder. The crystal structure of the binder phase depends on the concentration of Ti and Hf that remain in the binder after cooling and the carbide phase in which the binder is embedded. Analysis of TEM electron diffraction patterns show that the binder phase consists of cubic solid solutions as well as intermetallic and cubic phases in which atomic ordering is observed.
- Format
- ix, 148 leaves
- Format
- Publisher
- Nelson Mandela Metropolitan University
- Publisher
- Faculty of Science
- Language
- English
- Rights
- Nelson Mandela Metropolitan University
- Hits: 725
- Visitors: 648
- Downloads: 38
Collections
NMMU School of Computer Science, Mathematics, Physics and Statistics
| Thumbnail | File | Description | Size | Format | |||
|---|---|---|---|---|---|---|---|
| View Details Download | SOURCEPDF | 10 MB | Adobe Acrobat PDF | View Details Download |