- Title
- Microstructure and properties of zirconium silicide surface layers on zirlo for improved nuclear fuel cladding
- Creator
- Ngongo, Sinoyolo
- Subject
- Zirconium alloys Zirconium
- Date Issued
- 2017
- Date
- 2017
- Type
- Thesis
- Type
- Masters
- Type
- MSc
- Identifier
- http://hdl.handle.net/10948/20098
- Identifier
- vital:29107
- Description
- Zirconium alloys have important applications as nuclear reactor fuel cladding material. In this study the microstructure and properties of zirconium silicide synthesized by heating ZIRLO (which is an alloy of zirconium and niobium) in contact with silicon powder has been investigated. The silicide acts as a coating layer to protect the ZIRLO from oxidation which is associated with hydrogen pick-up. Scanning electron microscopy (SEM) and transmission electron microscopy (TEM) were used to investigate the morphology and crystal structure of the silicides respectively. Heating of ZIRLO with silicon powder was carried out in a Webb 89 Vacuum Furnace for various temperatures (1000–1400 °C) and times (4–8 hours) in an argon atmosphere or under vacuum, which resulted in the diffusion of silicon into the ZIRLO and the formation of zirconium silicide layers. The sample heat treated for 8 hours at 1000 °C did not show any evidence of inter-diffusion between the ZIRLO and silicon, this suggests that a temperature of 1000 °C is not sufficient to facilitate the formation of a silicide layer. The formation of the silicide layer was however observed after heat treatments at 1200 °C and 1400 °C using SEM and TEM. The silicide formed at 1200 °C as a layer on the ZIRLO sample and voids were observed in this layer, most likely due to the Kirkendall effect which occurs in solid state diffusion. The results suggest that Zr has a larger flux than Si as the voids formed in the ZIRLO. The temperature of 1400 °C appears to exceed the ideal required for silicide formation on the surface of ZIRLO, since the silicon infiltrated very far into the ZIRLO and in fact reacted with the entire ZIRLO sample. Both these samples were heat treated for 8 hours in an argon atmosphere. Silicide layers without voids were obtained in the case where ZIRLO and Si were heat treated for 8 and 4 hours at 1200 °C in an argon atmosphere and under vacuum respectively. The average penetration rate, calculated from the aforementioned heat treatments, of Si into Zr was calculated to be 4.5 μm/hour. The diffusion coefficient of Si in Zr was also estimated and it differs by about a factor of 104 from the reported value Zr into Si diffusion coefficient.
- Format
- xiv, 88 leaves
- Format
- Publisher
- Nelson Mandela Metropolitan University
- Publisher
- Faculty of Science
- Language
- English
- Rights
- Nelson Mandela Metropolitan University
- Hits: 1033
- Visitors: 1101
- Downloads: 104
Collections
NMU School of Computer Science, Mathematics, Physics and Statistics
| Thumbnail | File | Description | Size | Format | |||
|---|---|---|---|---|---|---|---|
| View Details Download | SOURCE1 | Adobe Acrobat PDF | 4 MB | Adobe Acrobat PDF | View Details Download |