Dynamics of charge movement in ∞-Al2O3:C,Mg using thermoluminescence phototransferred and optically stimulated luminescence
- Authors: Lontsi Sob, Aaron Joel
- Date: 2022-04-08
- Subjects: Thermoluminescence , Optically stimulated luminescence , Phototransfer , Deep traps , Phototransferred thermoluminescence (PTTL)
- Language: English
- Type: Academic theses , Doctoral theses , text
- Identifier: http://hdl.handle.net/10962/294607 , vital:57237 , DOI 10.21504/10962/294607
- Description: The dosimetric features of ∞-Al2O3:C,Mg have been investigated for unannealed and annealed samples. The unannealed sample is referred to as sample A whereas the samples annealed at 700, 900 and 1200°C for 15 minutes each are referred to as samples B, C and D respectively. A glow curve of unannealed ∞-Al2O3:C,Mg measured at 1°C/s after irradiation to 2.0 Gy consists of peaks at 43, 73, 164, 195, 246, 284, 336 and 374°C respectively. For sample B (annealed at 700°C), a glow curve measured at 1°C/s after irradiation to 3.0 Gy has peaks at 46, 76, 100, 170, 199, 290, 330 and 375°C whereas the glow curve of sample C (annealed at 900°C) recorded under the same conditions consists of peaks at 49, 80, 100, 174, 206, 235, 290, 335 and 375°C respectively. Sample D (annealed at 1200°C) is the most sensitive of the four samples. A glow curve of sample D measured at 1°C/s after irradiation to 0.2 Gy has peaks at 52, 82, 102, 174, 234, 288 and 384°C respectively. The peaks are labelled I-VIII in order of appearance. The 100°C peak, labelled IIa, is induced by annealing at or above 700°C. The dose response of these peaks was studied for doses within 0.1-8.2 Gy. The reported peaks follow first-order kinetics irrespective of annealing temperature. Peaks I-III of each sample are reproduced under phototransfer for preheating up to 400°C. For the unannealed sample, the reproduced peaks are labelled A1-A3 whereas for the annealed samples, they are labelled B1-B3, C1-C3 and D1-D3 respectively. The annealing-induced peak at 100°C is reproduced as B2a, C2a and D2a for samples B, C and D respectively. A PTTL peak labelled C2b or D2b is also observed near 140°C in samples C and D. In addition to these PTTL peaks, a PTTL peak corresponding to peak IV is also found for sample D and for the unannealed sample. As the corresponding conventional peaks, the PTTL peaks of each sample follow first-order kinetics. Peak I and its corresponding PTTL peak for each sample are unstable and fade to a minimal level after 300 s of storage time. On the other hand, peak II of each sample and its corresponding PTTL peak could still be observed with delay up to 5000 s. Peak III of the unannealed sample remains stable with storage time up to 48 hours. Irrespective of annealing, the trap corresponding to peak III is the most sensitive to optical stimulation. Time-dependent profiles of PTTL from unannealed and annealed ∞-Al2O3:C,Mg were also studied. The mathematical analysis of the PTTL time-response profiles is based on experimental results. The role of various electron traps in PTTL was determined by using pulse annealing and by monitoring the dependence of peak intensity on duration of illumination for peaks not removed by preheating. The presence and role of deep traps were further demonstrated with thermally assisted optically stimulated luminescence. For the unannealed sample, the activation energy for thermal assistance is 0.033 ± 0.001 eV and the activation energy for thermal i quenching is 1.043 ± 0.001 eV. For sample C, the activation energy for thermal assistance is 0.044 ± 0.003 eV whereas that for thermal quenching is 1.110 ± 0.006 eV. The values for the activation energy for thermal assistance are lower than those reported in literature. Only the values for the activation energy for thermal quenching are somewhat comparable to values reported elsewhere. , Thesis (PhD) -- Faculty of Science, Physics and Electronics, 2022
- Full Text:
- Date Issued: 2022-04-08
- Authors: Lontsi Sob, Aaron Joel
- Date: 2022-04-08
- Subjects: Thermoluminescence , Optically stimulated luminescence , Phototransfer , Deep traps , Phototransferred thermoluminescence (PTTL)
- Language: English
- Type: Academic theses , Doctoral theses , text
- Identifier: http://hdl.handle.net/10962/294607 , vital:57237 , DOI 10.21504/10962/294607
- Description: The dosimetric features of ∞-Al2O3:C,Mg have been investigated for unannealed and annealed samples. The unannealed sample is referred to as sample A whereas the samples annealed at 700, 900 and 1200°C for 15 minutes each are referred to as samples B, C and D respectively. A glow curve of unannealed ∞-Al2O3:C,Mg measured at 1°C/s after irradiation to 2.0 Gy consists of peaks at 43, 73, 164, 195, 246, 284, 336 and 374°C respectively. For sample B (annealed at 700°C), a glow curve measured at 1°C/s after irradiation to 3.0 Gy has peaks at 46, 76, 100, 170, 199, 290, 330 and 375°C whereas the glow curve of sample C (annealed at 900°C) recorded under the same conditions consists of peaks at 49, 80, 100, 174, 206, 235, 290, 335 and 375°C respectively. Sample D (annealed at 1200°C) is the most sensitive of the four samples. A glow curve of sample D measured at 1°C/s after irradiation to 0.2 Gy has peaks at 52, 82, 102, 174, 234, 288 and 384°C respectively. The peaks are labelled I-VIII in order of appearance. The 100°C peak, labelled IIa, is induced by annealing at or above 700°C. The dose response of these peaks was studied for doses within 0.1-8.2 Gy. The reported peaks follow first-order kinetics irrespective of annealing temperature. Peaks I-III of each sample are reproduced under phototransfer for preheating up to 400°C. For the unannealed sample, the reproduced peaks are labelled A1-A3 whereas for the annealed samples, they are labelled B1-B3, C1-C3 and D1-D3 respectively. The annealing-induced peak at 100°C is reproduced as B2a, C2a and D2a for samples B, C and D respectively. A PTTL peak labelled C2b or D2b is also observed near 140°C in samples C and D. In addition to these PTTL peaks, a PTTL peak corresponding to peak IV is also found for sample D and for the unannealed sample. As the corresponding conventional peaks, the PTTL peaks of each sample follow first-order kinetics. Peak I and its corresponding PTTL peak for each sample are unstable and fade to a minimal level after 300 s of storage time. On the other hand, peak II of each sample and its corresponding PTTL peak could still be observed with delay up to 5000 s. Peak III of the unannealed sample remains stable with storage time up to 48 hours. Irrespective of annealing, the trap corresponding to peak III is the most sensitive to optical stimulation. Time-dependent profiles of PTTL from unannealed and annealed ∞-Al2O3:C,Mg were also studied. The mathematical analysis of the PTTL time-response profiles is based on experimental results. The role of various electron traps in PTTL was determined by using pulse annealing and by monitoring the dependence of peak intensity on duration of illumination for peaks not removed by preheating. The presence and role of deep traps were further demonstrated with thermally assisted optically stimulated luminescence. For the unannealed sample, the activation energy for thermal assistance is 0.033 ± 0.001 eV and the activation energy for thermal i quenching is 1.043 ± 0.001 eV. For sample C, the activation energy for thermal assistance is 0.044 ± 0.003 eV whereas that for thermal quenching is 1.110 ± 0.006 eV. The values for the activation energy for thermal assistance are lower than those reported in literature. Only the values for the activation energy for thermal quenching are somewhat comparable to values reported elsewhere. , Thesis (PhD) -- Faculty of Science, Physics and Electronics, 2022
- Full Text:
- Date Issued: 2022-04-08
Thermoluminescence of natural quartz
- Authors: Lontsi Sob, Aaron Joel
- Date: 2014
- Subjects: Thermoluminescence , Quartz , Thermoluminescence dosimetry
- Language: English
- Type: Thesis , Masters , MSc
- Identifier: vital:5543 , http://hdl.handle.net/10962/d1013358
- Description: The kinetic and dosimetric features of the main thermoluminescence peak of quartz have been investigated in unannealed as well in quartz annealed at 500˚C for 10 minutes. The main peak is found at 92 and 86˚C respectively for aliquots of unannealed and annealed samples irradiated to 10 Gy and heated at 5.0˚C/s. For each sample, the intensity of the main peak is enhanced with repetitive measurement whereas its maximum temperature is unaffected. The peak position of the main peak in each sample is independent of the irradiation dose and this, together with its fading characteristics are consistent with first-order kinetics. For low doses, typically between 2 and 10 Gy, the dose response of the main peak in each sample is linear. In the intermediate dose range from 10 to 60 Gy, the growth of the main peak in each sample is sub-linear and for greater doses, in the range from 60 Gy to 151 Gy, it is linear again. The half-life of the main peak of the unannealed sample is about 1.3 h whereas that of the annealed sample is about 1.2 h. The main peak in each sample can be approximated to a first-order glow peak. As the heating rate increases, the intensity of the main peak in each sample decreases. This is evidence of thermal quenching. The main peak in each sample is the only peak regenerated by phototransfer. The resulting phototransferred peak occurs at the same temperature as the original peak and has similar kinetic and dosimetric features. For a preheat temperature of 120˚C, the intensity of the phototransferred peak in each sample increases with illumination time up to a maximum and decreases afterwards. At longer illumination times (such as 30 min up to 1 h), no further decrease in the intensity of the phototransferred peak is observed. The traps associated with the 325˚C peak are the main source of the electrons responsible for the regenerated peak. Radioluminescence emission spectra were also measured for quartz annealed at various temperatures. Emission bands in quartz are affected by annealing and irradiation. A strong enhancement of the 3.4 eV (~366 nm) emission band is observed in quartz annealed at 500˚C. A new emission band which grows with annealing up to 1000˚C is observed at 3.7 eV (~330 nm) for quartz annealed at 600˚C. An attempt has been made to correlate the changes in radioluminescence emission spectra due to annealing with the influence of annealing on luminescence lifetimes in quartz.
- Full Text:
- Date Issued: 2014
- Authors: Lontsi Sob, Aaron Joel
- Date: 2014
- Subjects: Thermoluminescence , Quartz , Thermoluminescence dosimetry
- Language: English
- Type: Thesis , Masters , MSc
- Identifier: vital:5543 , http://hdl.handle.net/10962/d1013358
- Description: The kinetic and dosimetric features of the main thermoluminescence peak of quartz have been investigated in unannealed as well in quartz annealed at 500˚C for 10 minutes. The main peak is found at 92 and 86˚C respectively for aliquots of unannealed and annealed samples irradiated to 10 Gy and heated at 5.0˚C/s. For each sample, the intensity of the main peak is enhanced with repetitive measurement whereas its maximum temperature is unaffected. The peak position of the main peak in each sample is independent of the irradiation dose and this, together with its fading characteristics are consistent with first-order kinetics. For low doses, typically between 2 and 10 Gy, the dose response of the main peak in each sample is linear. In the intermediate dose range from 10 to 60 Gy, the growth of the main peak in each sample is sub-linear and for greater doses, in the range from 60 Gy to 151 Gy, it is linear again. The half-life of the main peak of the unannealed sample is about 1.3 h whereas that of the annealed sample is about 1.2 h. The main peak in each sample can be approximated to a first-order glow peak. As the heating rate increases, the intensity of the main peak in each sample decreases. This is evidence of thermal quenching. The main peak in each sample is the only peak regenerated by phototransfer. The resulting phototransferred peak occurs at the same temperature as the original peak and has similar kinetic and dosimetric features. For a preheat temperature of 120˚C, the intensity of the phototransferred peak in each sample increases with illumination time up to a maximum and decreases afterwards. At longer illumination times (such as 30 min up to 1 h), no further decrease in the intensity of the phototransferred peak is observed. The traps associated with the 325˚C peak are the main source of the electrons responsible for the regenerated peak. Radioluminescence emission spectra were also measured for quartz annealed at various temperatures. Emission bands in quartz are affected by annealing and irradiation. A strong enhancement of the 3.4 eV (~366 nm) emission band is observed in quartz annealed at 500˚C. A new emission band which grows with annealing up to 1000˚C is observed at 3.7 eV (~330 nm) for quartz annealed at 600˚C. An attempt has been made to correlate the changes in radioluminescence emission spectra due to annealing with the influence of annealing on luminescence lifetimes in quartz.
- Full Text:
- Date Issued: 2014
- «
- ‹
- 1
- ›
- »