- Title
- On the development of ZnO nanorods on silicon substrate for light-emitting diode applications
- Creator
- Djiokap, Stive Roussel Tankio
- Subject
- Zinc oxide
- Subject
- Chemical reactions
- Subject
- Compound semiconductors
- Date Issued
- 2018
- Date
- 2018
- Type
- Thesis
- Type
- Doctoral
- Type
- DPhil
- Identifier
- http://hdl.handle.net/10948/29973
- Identifier
- vital:30802
- Description
- The interest in zinc oxide (ZnO), a promising material for blue/ultraviolet light emitting devices, arises from its large exciton binding energy (60 meV). The main challenge associated with this promising compound semiconductor, however, arises from the difficulty to achieve stable and/or reproducible p-type doping. Since silicon (Si) technology still dominates the semiconductor industry, the objective of this thesis is to probe into the possibility of using ZnO nanorods (NRs) on p-type silicon for opto-electronic devices. ZnO NRs have been grown on seeded Si, as well as on nickel oxide (NiO) and aluminum nitride (AlN) coated Si, using a two-step chemical bath deposition (CBD) process. Various techniques, including X-ray diffraction (XRD), scanning electron microscopy (SEM), photoluminescence (PL) spectroscopy and transmission electron microscopy (TEM), have been used to characterize the samples. The electrical characteristics of the heterojunction between the substrate and the ZnO nanostructures were evaluated by current-voltage (I-V) and capacitance-voltage (C-V) measurements. SEM and XRD studies have confirmed that, irrespective of the orientation of the Si substrate (Si (100) and Si (111)), the two-step CBD process yielded NRs that crystallised in the wurtzite structure and exhibited a hexagonal shape. Most of the rods developed perpendicularly to the surface of the substrate, with the orientation and distribution of the rods dictated by the seed layer density. Similarly, irrespective of the substrate, the luminescence of the ZnO nanostructures is dominated by near band edge (NBE) emission in the UV region (~ 3.29 eV) and deep level emission (DLE) in the visible region (2 eV to 2.6 eV). Annealing at moderate temperatures (~ 300 °C) increased the NBE emission and decreased the DLE. The removal of surface adsorbed impurities and enhanced defect passivation by hydrogen are responsible for these changes. The diode characteristics of the ZnO/Si heterojunction was studied by I-V and C-V measurements. Rectification was observed when the Si substrate had a relatively low acceptor density of ~1016 cm-3, while diodes produced on substrate with p ~1018 cm-3 were ohmic. From the C-V analysis the donor density in the ZnO was deduced to be ~1018 cm-3. In the case of rectifying junctions, thermionic emission did not dominate the charge transport. The carrier transport mechanism was therefore probed by the temperature dependent I-V xiii measurements (100 K to 295 K). Defect-assisted multistep tunneling was deduced to dominate in the n-ZnO/p-Si diodes at low forward bias. The band alignment between n-ZnO and p-Si predicts a much smaller barrier for electrons than for holes at the interface, which results in recombination on the Si side of the junction for a forward-biased diode. NiO intermediate layers (formed on Si by the thermal oxidation of Ni) were used to reduce electron injection from ZnO into Si. Scanning probe microscopy (SPM) and XRD analysis showed that while the grain size of the poly-crystalline NiO increased with NiO film thickness, the orientation and distribution of the subsequently grown ZnO nanorods were unaffected by the underlying NiO layer. Also, the photoluminescence response of the ZnO rods remained unchanged. I-V measurements did illustrate rectifying behaviour, with both the forward and reverse currents strongly decreased due to the resistive nature of the NiO. In another attempt at confining electrons to the ZnO side of the junction, AlN-coated Si (111) was used as a substrate for ZnO nanorods. CBD parameters that normally yield nanorods resulted in a plate-like architecture of the ZnO. By modifying the ZnO seed density on the AlN/Si substrate, the rod-like morphology could be recovered. Both the forward and reverse current decreased in these diodes. From studies aimed at identifying the transport mechanism it was concluded that trap-assisted tunnelling, resulting from a high density of defects in the seed layer, dominates in these devices. In conclusion, while no ZnO electroluminescence could be achieved from any of the devices, this study provides insight into the transport mechanisms in n-ZnO/barrier/p-Si heterostructures and highlights the importance of the heterointerface quality for light emitting devices.
- Format
- xiii, 116 leaves
- Format
- Publisher
- Nelson Mandela University
- Publisher
- Faculty of Science
- Language
- English
- Rights
- Nelson Mandela University
- Hits: 1581
- Visitors: 1561
- Downloads: 79
Collections
NMU School of BioMolecular and Chemical Sciences
| Thumbnail | File | Description | Size | Format | |||
|---|---|---|---|---|---|---|---|
| View Details Download | SOURCE1 | Stive Roussel Tankio Djiokap.pdf | 4 MB | Adobe Acrobat PDF | View Details Download |